Celluvisc 1% Eye drops Solution (carmellose sodique) 30 single-use containers.

Wash your hands. Make sure that the twist-off cap is still fully attached to the vial. You should not allow the open-end of the Celluvisc 1% Eye Drops vial to touch your eye or any other surface. Hold, the vial upright (with the cap uppermost) and twist-off the cap. Pull-down the lower lid of the affected eye(s) to form a pocket. Apply the eye drops into the eye-pocket as required or according to the instructions given to you by your pharmacist or doctor. Blink your eyes a few times. The contents of a single vial should be enough for both eyes if required. Once the drops have been applied you should throw away the vial-even if some solution remains.

Also contains Sodium Chloride, Sodium Lactate, Potassium Chloride, Calcium Chloride and Purified Water. Read enclosed Patient Information Leaflet before use.

Each 0.4ml single dose container contains the active ingredient Carmellose Sodium 10mg/ml.

For external use only. Do not store above 25°C. Celluvisc is used to treat the symptoms of 'dry eye' these may be soreness, burning, irritation or dryness. Warning: May cause momentary blurring. Do not drive or operate machinery unless vision is clear. If irritation, pain, redness and changes in vision occur or worsen, discontinue use and consult a doctor. Contact lenses should be removed before each application and may be inserted after 15 minutes. To avoid contamination, do not touch the tip to the eye or any surface. Discard opened vial after use. If you are using other medication in the eye, you should apply them 15 minutes before you apply your Celluvisc drops. Keep out of the reach and sight of children.
If you are unsure about your health condition always speak to a medical professional. All content on this website is for information purposes only and should not be taken as professional medical advice. Always read the label prior to using any product.